How to configure an IPoE connection on your modem

Caution!  An IPoE configuration will typically only be used by some Static IP customers. We recommend that you do not change this setting unless advised to do so by a technician. 

5. Select WAN Settings in the left sidebar menu.

Configurar Conexión CBRAS, Paso 5 

6. Select Auto Select from the drop-down for the ISP Protocol, then Apply.

Configurar Conexión CBRAS, Paso 6 

7. Select LAN Subnets in the next section of the side menu.

Configurar Conexión CBRAS, Paso 7 

8. Ingresa el nombre para la subred LAN que quieres crear.  Nota: El nombre de subred LAN no puede contener espacios.

Configurar Conexión CBRAS, Paso 8 

9. Selecciona las interfaces que quieres asociar con la subred que estás agregando. La mayoría de los usuarios seleccionará Ethernet 1, Ethernet 2, Ethernet 3 y Ethernet 4.

Configurar Conexión CBRAS, Paso 9 

10. Select Enable next to both "IPv4 Addressing State" and "Modem IPv4 Admin Access."

Configurar Conexión CBRAS, Paso 10 

11. Ingresa la Dirección de Red en "Network Address," la máscara de subred en "Subnet Mask" y la dirección de la puerta de enlace ("Gateway Address") que te informaron cuando arrendaste la dirección IP.

Usuarios de Zyxel: si tienes un módem Zyxel, es posible que propague incorrectamente de manera automática la dirección de la puerta de enlace. Haz clic en el campo "Gateway Address" e ingresa la dirección que te dieron cuando arrendaste tu dirección o direcciones IP Estáticas. Si necesitas ayuda para encontrar esta información, contáctanos.

Configurar Conexión CBRAS, Paso 11 

12. Select Apply to save your changes.

Configurar Conexión CBRAS, Paso 12 

Did you find the help you were looking for today?